New Front Office Software and USB programmer are now available.  Features include a complete data base, Crystal accounting reports, and a ticker to show last transactions.  

The new 4 Trap Claymate Wi Card Sporting Controller is now available and will surely be a big hit for customers who are limited on space and would like to add a few traps for Super Sporting or 4 trap Sporting.  

The new 5 Trap Claymate wireless transmitter is now available. The 5 Trap Claymate is easier to hold when one person is performing pulling and scoring on FITASC.

DANIELLE PACK - FRONT OFFICE      

SKYLER SWITLIK - OPERATIONS MANAGER

INTRODUCES NEW PROMATIC PRODUCTS   

NEW MOTOR KIT FOR RANGER SERIES 

We have a new motor kit for the Ranger series motors that will help eliminate water ingression. The kit will come with heat shrink and new wires so the wiring can be run towards the rear of the motor. It is easy to install by simply cutting the motor wires and plugging in the new connectors and heating the shrink tube with a heat gun. The Motor Kit can be used on Harriers and Eagles as well.

NEW PROMATIC 4 PIN CONNECTOR  

1. Brown = 12 V+ will go to Pin 1
2. Green = 12 V- will be go to Pin 2
3. Blue = Trigger will go to Pin 3   

NEW LARGE GEARBOX COVER 

We are now offering a gearbox cover for the large gearboxes. It is made out of SBR rubber and should help keep the UV off of the top gearbox seal.  

COLBY CUNNINGHAM - SALES & SERVICE 

CHECK PLATE HEIGHT ON NEW PROMATIC MACHINES  

On the new Promatic machines check the plate height as your machine breaks in and once it is seated with the temperature changes you should hit a balance point for maximum performance.  

Promatic Transport Mode & Spring Change Procedure on RH Trap   

1. Standing behind the trap, disarm trap using the disarm switch.
2. Bump the disarm switch until the gearbox cocking lever is in the 11:00 or 12:00 position (looking at it from the back of trap over the top side of the carousel).
3. While still standing at the rear of the trap, pull the arm with your left hand towards the center of the trap. You should feel the arm go over center and spring pressure should be felt on the arm as the main shaft presses against the gearbox cocking lever.
4. If you do not feel the spring tension, force the main shaft against the gearbox cocking lever, bump the disarm switch lightly, and push the arm in again.

DARRAN IDE - SERVICE TECH EXTRAORDINAIRE 

SERVICING YOUR RANGER GEARBOX  

Servicing you gear box once a year can add years to its life. On the Ranger style EMD boxes remove the cocking lever and rotate it a couple teeth once a year so it will not be engaging the same teeth. Remove the drain plug on the large gear box and drain and refill the oil. 

MAC MCGREGOR - ELECTRONICS MANAGER   

You can check your complete electrical system with the use of a volt ohm meter at the machine connection.

ROLLER SWITCH  

Before checking continuity, be sure the roller lever operates freely and the wheel mounting is secure and not worn.

1. Connect the negative cable from the trap to the negative side of good 12v DC battery.
2. Disconnect the positive cable from the trap from the battery.
3. Select the Ohm scale on the Digital Volt Meter.
4. Secure the negative lead on the Digital Volt Meter to the "L" (ground) terminal on the Duraplug or pin #2 on the 4 pin connector.
5. Secure the positive side of test leads to the "N" (trigger) terminal on the Duraplug or pin #3 on the 4 pin connector.
6. Manually rotate the Roller Switch from side to side. This should open and close the circuit. When the switch is straight out (rest position) the switch will measure closed on the meter.