Labor Prompts in CCC - Labor prompts need to be setup for Edging, Underside, Inside, Bumper Refinish, Aim Lamps and Evacuate/Recharge in CCC ONE. These prompts can be displayed when writing an estimate and you set the "default" in the profile section. Go to Configure, Profiles, Select Your Profile, and then click Labor Prompts. This must be done for each profile in your system. 

 

 

You can view this tip and others on the DEG website by clicking here!

 

 

For more information about SCRS, or to join as a member, please visit www.scrs.com, call toll free 1-877-841-0660 or email us at [email protected].