| Instantly Increase Production!
|
Attention Production Manager,
Miller Weldmaster manufactures a variety of equipment for the production of tarpaulins, truck tarps, and covers. Miller will design a completely automated machine to fit you specific production needs. Take a look at the equipment below and see how you can instantly increase your production while decreasing labor cost.
For more information on various tarpaulin production equipment:
|
M-100 Mesh Tarp Machine
This M-100 was designed to pull fabric off roll and weld hems on both sides while simultaneously punches grommets on both edges. This system is also designed to cut to length while continuously welding.
|
M-100 Tarpaulin Machine
This M-100 pulls fabric off of multiple rolls and welds up to 7 overlap seals and hems on both edges. This system also marks a perpendicular and lateral D-ring layout line and cuts to a desired length.
|
Soft Side Curtains
These fully automated systems are designed to dispense and weld webbing strips in pre-determined locations while indexing the panel to its next location.
These systems are designed to greatly increase production while substantially reducing labor costs.
|
Soft Side Curtains
This M-100 pulls fabric off an unwind and welds multiple webbings and reinforcement strips simultaneously while cutting the products to length.
|
|
|
Soft Side Curtains
This custom automated system was designed to weld webbing in both the horizontal and vertical direction on four curtains at the same time with the use of a large vacuum table, and automatic dispensing and cut to length welding heads.
These systems are designed to greatly increase production while substantially reducing labor costs.
|
M-100 Large Covers
This M-100 pulls fabric off of multiple rolls and is designed to weld up to three overlap seams and rewind the final product. The resulting roll is only 12 ft. wide when rewound, but unfolds to 48 ft wide.
|
M-100 Tarpaulin with Keder
This M-100 pulls fabric off of two unwinds and welds an overlap while simultaneously creating and welding a two-sided keder to each edge of the finished panel.
|
|
M-100 Silage Covers
This M-100 was designed to adjoin two rolls of multi-layered pre-folded blown film with a fold overlap seam. This system will then cut the product to length or rewind it into master rolls for distribution.
|
